Pipe Bending Calculators
Pipe offset calculator
Find the mark spacing for two equal bends.
Your measurements
Measure from the centre of one pipe run to the centre of the other.
Type an angle or choose a preset.
Estimated mark spacing
99 mm
70 mm × 1.414 ≈ 98.99 mm
Measure this spacing along the straight pipe.
From measurement to bend
Watch the offset lessonMeasure the offset
Measure straight across from the centre of the existing pipe run to the centre of the new one.
Set out the bends
Use the calculated spacing as your starting point. Check it on a scrap piece using your bender’s marking reference.
Bend and check
Make both bends to the same angle in opposite directions, in the same plane. Check the finished offset and that the legs are parallel.
How the calculation works
The centre-to-centre offset is the side opposite the bend angle in a right triangle. Dividing it by the sine of the angle gives the diagonal travel. The calculator uses the full multiplier before rounding the workshop measurement to the nearest millimetre.
Handlebar crossover calculator
Set out four bends in copper pipe.
Your measurements
Centreline to centreline
Straight across the top
Bend settings30°
Estimated bend radius: 60 mm (4 × pipe diameter).
Use a measured radius
Leave blank to use the estimate for this pipe size.
Angle of each bend
Four bend marks
Measure from mark 1. Bend outwards.
- Bend 10 mmUp
- Bend 252.3 mmLevel
- Bend 3112.3 mmDown
- Bend 4164.5 mmLevel
Bend order
- 2 → 3Make the bridge
- 1 → 4Bring the ends back in line
- Finished span
- 216.1 mm
- Length on straight pipe
- 227.4 mm
Using an estimated 60 mm radius. Measure on straight pipe. At each mark, orient the bender so the curve starts at the mark and runs towards the nearest pipe end. Check alignment and clearance on a test bend.
From the first mark to the fourth
Two-bend offset calculatorMeasure the rise and top
Measure the rise from the original pipe centreline to the raised centreline. Allow enough height and straight length at the top to clear the obstruction.
Mark from one end
Use mark 1 as zero. Leave enough pipe beyond the outer marks for both outer curves, the bender grip and the final connections. Finished span is measured across all four curves.
Bend and check
Use the same start-of-bend reference on both sides. Bend 2 and 3 away from the bridge, turning the pipe end-for-end between sides. Then bend 1 and 4 towards the tails to bring the ends back in line. Keep all four bends in the same plane and check the fit on scrap.